Listen for the vehicle s horn to chirp one time.
2010 ford explorer door lock making locking noise.
This will require the driver to use the key to lock or unlock the doors and can disable the power door.
The latch and mechanical lock are the same unit.
That may lead you to think the door lock actuator linkage is binding.
If the electric motor or the mechanism inside the door lock actuator wears out the door lock may lock or unlock slowly or work sometimes but not all the time.
Press and hold both the lock and unlock buttons on the remote for at least two seconds.
For vehicles equipped with door lock cylinders the door can still be opened using the key.
Press the power door lock lock button once to enter the command.
The horn should honk one time.
Your dealer or regular.
Watch for the hazard lights to flash once.
However vehicles without door lock cylinders will not be able to lock or unlock the doors until power is restored.
Inside the module there is a track on which two electrical contacts slide along with the actuator and a small rubber bumper stop.
Unusual noises coming from inside the door are one of the first symptoms of a potential problem with a power door lock actuator.
You will be able to open the hatch by sliding the lever sideways.
Press the power door lock unlock button one time to command the rap module to toggle the autolock relock feature on or off.
The module is buried down in the lower outside corner of the door.
1998 ford windstar fuse problem dome light stays on etc you most likely have a bad door ajar switch the door panel has to be removed to access it its on the door latch you can unplug them this will take care of the batt drain prob as for the locks it may be a switch problem most ford vehicles will not let you lock the vehicle from the driver s door when it s open to prevent.
It was caused by a deteriorated rubber stop inside the door lock actuator module.
For vehicles with traditional style door lock cylinders and keys a bad power door lock relay will merely disable the power door lock feature.
Another symptom of a potential problem with the door lock actuators are power door locks that do not function.
Most power door locks operate using gears or motors that may.
Lock the doors and confirm that the horn does not sound.
Turn the ignition switch to the off position to exit the enable disable mode.
If you want to reactivate the beep feature.
In a partial failure you ll hear some noise coming from the door panel and the manual door lock button may appear to move slightly but not enough to completely lock or unlock the door.
In some cars a door lock actuator becomes noisy and produces a squeaking or buzzing noise when the power door locks are locked or unlocked.
If the door lock actuators fail they will disable the power door lock feature from working.
