The blend door hot cold actuator is on the drivers side and closest to the seat.
2008 dodge nitro blend door actuator location.
Disconnect the wire harness connector from the blend door actuator located on the driver side of the air distribution housing.
Where is the heater blend door in a 2008 dodge nitro heater blows cold air dodge 2008 nitro question.
2008 dodge nitro air blend door acuater.
If heater core is getting coolant circulating through it then you may have a temp blend door or blend door actuator not working properly.
If both are hot then you might have a problem will the what they call a blend door actuator.
Remove the two screws that secure the blend door actuator to the actuator mounting bracket and remove the actuator.
Search fixya browse categories.
My husband changed the thermostat and also flushed the he.
Disconnect the wire harness connector from the blend door actuator located on the driver side of the air distribution housing.
The actuators are on the side of the hvac housing forward and between the seats under the radio.
Both need to be diagnosed be a mechanic because they will required the dash to be removed to be repaired.
Remove the two screws that secure the blend door actuator to the actuator mounting bracket and remove the actuator.
At least that is what i assume.
It was the blend door actuator but the wheels continued to turn because the reset operation requires resistance to know when the blend door is at its limit for the hot and cold side.
And the heater is not working.
Remove the two screws that secure the blend door actuator to the actuator mounting bracket and remove the actuator.
Disconnect the wire harness connector from the blend door actuator located on the driver side of the air distribution housing.
The other one on the drivers side is the mode door vent floor defrost it it higher up and very close to the firewall.
I have a 2008 a dodge nitro.
Where is the heater blend door on a 2008 dodge nitro.
I don t have a nitro so can t tell you if this procedure is correct.
If the actuator is tested off of the blend door it will simply turn.
